Home > News > Information >

The Manufacture and Supply of Ringlock Scaffolding System

News Group
The Manufacture and Supply of Ringlock Scaffolding System
Issue Time:2019-08-23
Ringlock artifacts and steel tube scaffold manufacturer whole flow processing by oneself, can undertake bridge engineering, ground engineering, tunnel engineering, equipment maintenance, electric power, water conservancy, bridge, municipal, etc. All ringlock scaffolding components process choose factory processing components, welding way choose automation welding equipment, welding seam muddy real plump, without air hole, burr and hang drop.

Ringlock scaffolding choose JGJ231 specification requirements of Q345B high strength low alloy structural steel, the clever design can and now most of the 10 * 10 cm squares collocation is used, common rail length is 1.8 meters and 1.8 meters, 1.2 meters, 0.9 meters. Steel bearing strength, than traditional bowl frame steel tube 1.5 2 times higher bearing capacity, thus to a high standard specification of construction projects, and I fully qualified engineering group company standards.

Ringlock scaffold poling common length of 1 m, 1.5 m, 2 m, 2.5 m and 3 m, each vertical bar at the top of the 100 mm reserve, reserve at the bottom of the 400 mm, consistent with the plate of a scaffold of disk space,

This ensures that all products are common length. So after each lap joint length is 500 mm in a safe range, poling docking means has two kinds, one kind is the connection, is a kind of external connection, poling unlimited high, but with specification are consistent, to timely cantilever and expert argumentation, etc. Hollow jacking, light weight save more labor workers day, reduce the construction difficulty, reduce the steel tube and hollow jacking box degree, improve the stability of the support system.